Skip to content

The machine

Work zero

Carry the project origin and Z zero over to the machine: work and machine positions, zero on XYZ or one axis, go to XY zero, and the paper method.

The work zero carries the project’s origin and Z zero over to the machine (see Origin and Z zero). Position section:

  • The Work (work zero coordinates, G54) and Machine positions, in project units.
  • Work zero: XYZ, X, Y, Z: the current tool position becomes the origin on these axes.
  • Probing…: see Probing.
  • Go to XY Zero: brings the tool above the work zero without changing Z.

Manual method: bring the tool tip above the corner (or the center) chosen as origin, set X and Y zero; go down in small steps until a sheet of paper is pinched between the tool and the stock, then set Z zero (subtract the paper’s thickness, about 0.1 mm, if precision matters). The pre-send check refuses a job as long as the work zero is not set.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.