Skip to content

Dusty Manual

Safety

The rules that protect you at a desktop CNC — spindle, eyes, hands, workholding, STOP and emergency stop — and the safeguards Dusty adds on its own.

A desktop CNC is still a machine tool. Dusty adds many safeguards, but none of them replaces your attention.

  • Spindle: never touch the bit, even slowly; wait for a full stop before reaching in. Tie back long hair, roll up sleeves, remove jewelry and gloves near a spinning tool (a glove can be pulled in).
  • Eyes, ears, lungs: safety glasses at all times; hearing protection for long jobs; dust extraction or a mask (MDF makes a lot of fine dust).
  • Hands: out of the work area as soon as the machine is connected and can move (jog, framing, job).
  • Stopping: STOP (⌘. on Mac, Ctrl+. in Studio on Windows and Linux, or the red button that is always visible while a machine is connected) resets the controller at once: motion interrupted, job abandoned, spindle and coolant off. It is a software stop: also keep the machine’s emergency stop (or its power switch) within reach. See Pause, stop and STOP.
  • Never unattended: stay near the machine for the whole job. Wood can heat and scorch, a bit can break, a part can come loose.
  • Workholding: clamp the stock firmly (screws, clamps, double-sided tape), clamps outside the toolpaths, and a safe height above anything that sticks up. Fit and remove clamps, screws and parts with the spindle stopped, never with a hand near the bit. See Workholding and Travel heights.
  • No-go zones: draw clamps and the vise, with their height: Dusty refuses paths that cross them, and blocks what it cannot check. See No-go zones.
  • First run of a project: frame the job to check its position, do a dry run (the job played above the stock, spindle off), then start with the feed rate halved (feed override at 50%).

What Dusty does to protect you: explicit confirmation before any spindle start, job start or resume; a pre-send check that blocks dangerous programs; continuous jogging stops if the interface no longer responds; a controlled stop when the connection is lost or the window closes during a job; macros and console commands checked before they are sent.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.