Skip to content

Dusty Manual

Tutorials

Eight example projects for a 3018-type hobby CNC, each rebuilt step by step from a blank page to the G-code, then sent to the machine.

Eight example projects come with Dusty, from the simplest to the most complete. Each one is set for a 3018-type hobby CNC (300 × 180 × 45 mm travel), with careful depths and feeds, and passes the pre-send check without any blocking finding. The following tutorials rebuild each project from a blank page to the G-code, then send it to the machine; you can also open the finished example and follow along.

In this section

  • Example projects

    Where to find the eight example projects, how they open as an untitled copy, and what each one shows: material, tools and estimated time on a 3018.

  • Before sending an example to the machine

    The checklist common to all tutorials: machine, tools, stock thickness, preview, workholding, zeros, framing and dry run, then a first start at 50 % feed.

  • Key rings cut out with tabs

    Three key rings cut out of 6 mm plywood with a 3.175 mm end mill: an outside profile, holes cut first, and tabs that keep the parts in place.

  • V-carved sign

    The word DUSTY V-carved into a 160 × 60 mm sign with a 60° V-bit, plus a border engraved on the line with the same tool: no tool change.

  • Single-line engraved ruler

    A 100 mm ruler engraved in a wooden strip with a 20° V-bit: graduations drawn as open lines and repeated by an array, digits in a single-line font.

  • Drill bit holder (drilling)

    A hardwood block drilled with fourteen holes to store drill bits: peck drilling with two drills and a tool change between the two rows.

  • Coaster imported from an SVG

    A drawing made in a vector program, imported from SVG with its sizes kept, then machined: a pocket for the motif and an outside profile with tabs.

  • Rest machining and tool change

    A star-shaped tray in MDF: a 6 mm end mill clears most of the pocket, then a 3.175 mm one finishes the points with a rest pocket after a tool change.

  • Cutting board and juice groove

    A hardwood cutting board: a juice groove cut with a ball nose bit, then a 15 mm cut-out with tabs, the groove first while the board is still held.

  • Finger-joint box and dogbones

    The sides and bottom of a plywood box joined by fingers and notches, with dogbones in every inside corner so that the square fingers fit in.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.