Skip to content

Dusty Manual

Workholding

How to hold the stock down on a desktop CNC: screws, clamps, tape, glue, jigs, brads, vacuum and vise, their limits, and what to check before starting.

Workholding fixes the stock to the table so that it does not move while machining. A bit pushes and pulls the material at every turn: badly held stock shifts (wrong dimensions), vibrates (poor finish), breaks the bit or gets thrown. This guide presents the usual methods on a desktop CNC, their limits and what to check before starting.

To fit or remove a clamp, a screw, a brad or a part: spindle stopped and still, machine idle (no job, framing or jog running; a switch-operated router turned off), safety glasses on, and never a hand under or near the bit. Move the tool away first (see Go to): a bit cuts even when it is not turning.

In this section

  • Choosing and checking

    What good workholding does, a table comparing the methods by use and limits, and five checks before the first cut: shake, draw, safe height, frame, slow start.

  • Screwing to the spoilboard

    Screw the stock into the spoilboard, the basic method for through cuts: screws in the waste, countersunk, brass or plastic, and not overtightened.

  • Clamps

    Step clamps, toggle clamps and side clamps: keep them level, put the stud near the stock, tighten moderately and raise the safe height above them.

  • Double-sided tape

    Stick thin sheets and small parts to the spoilboard with double-sided tape: clean surfaces, tape under each part, firm pressure, lighter passes.

  • Masking tape and cyanoacrylate glue

    Masking tape on the spoilboard and under the stock, a few dots of super glue in between: a very strong hold that peels off cleanly, with its precautions.

  • Jigs and indexing fixtures

    For series or two-sided parts, a jig machined on the CNC puts every part back in the same place: three contact points, work zero on the jig, dowel pins for flipping.

  • Machinable brads

    Plastic brads driven with a nailer through the stock into the spoilboard hold it with nothing sticking out, and a bit that hits one cuts it without damage.

  • Vacuum table

    A vacuum table holds the stock by suction: hold that depends on the area, leaks to cover, and how to switch the pump so that it never lets go mid-cut.

  • Table-mounted vise

    A milling vise on the table holds blocks, thick parts and soft metals: align the fixed jaw, use parallels, keep the bit above the jaws, zero on the fixed jaw.

  • Through cuts: tabs and thin last pass

    Keep a cut-out part in place until the very end: tabs, a thin last pass that leaves a skin, cutting 0.2 to 0.3 mm into the spoilboard, and inner details first.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.