Skip to content

Workholding

Double-sided tape

Stick thin sheets and small parts to the spoilboard with double-sided tape: clean surfaces, tape under each part, firm pressure, lighter passes.

Thin double-sided tape (woodworking, cloth or carpet tape) sticks the stock to the spoilboard. Quick, with nothing sticking out: ideal for thin sheets, small parts and engraving.

On the left, strips of tape (yellow) between the spoilboard and the stock, pressed down; on the right, top view: tape under each part to be cut out (blue).
  • Both surfaces must be clean, dry and dust-free: vacuum and wipe the spoilboard.
  • Put tape under each part that will be cut out, not just under the stock.
  • Press hard for a few seconds (mallet, press, weight): the hold comes from the pressure.
  • Limit the force: shallower passes, a slightly reduced feed. The glue softens if the bit heats up.
  • To remove, spindle stopped: slide a thin putty knife under the part, always pushing away from you and from your other hand, or use the solvent recommended by the tape maker.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.