Skip to content

Workholding

Through cuts: tabs and thin last pass

Keep a cut-out part in place until the very end: tabs, a thin last pass that leaves a skin, cutting 0.2 to 0.3 mm into the spoilboard, and inner details first.

When a profile cuts through the stock, nothing holds the part on the last pass: it can move, be nicked by the bit, or even be thrown. Two ways to keep it in place until the end, on top of holding the stock:

View along the unrolled contour: on the left, the cut goes through and into the spoilboard, except at the tabs (blue); on the right, a thin skin remains everywhere, removed by a last pass (dashed).
  • Tabs: small bridges of material remain on the contour; you cut them afterwards (wood chisel, saw), then sand (see Tabs: type, length, height, assistant). Count at least four tabs per part, more for a long part or a machine that vibrates.
  • Thin last pass: a first profile stops a few tenths above the spoilboard (for example at 0.3 mm), a second one, on the same shape with the same tool, cuts through in a single light pass: the remaining skin holds the part almost until the end. Combine it with tabs for small parts.
  • Take the last pass 0.2 to 0.3 mm into the spoilboard to cut through everywhere; Dusty warns that the tool cuts into the spoilboard: that is intended (see Common settings).
  • Machine holes and inner details before the outer contour (see Machining order): the part is still attached to the stock when they are cut.
  • If a part breaks free anyway: STOP, wait for the spindle to stop completely, then remove it.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.