Skip to content

Workholding

Clamps

Step clamps, toggle clamps and side clamps: keep them level, put the stud near the stock, tighten moderately and raise the safe height above them.

A clamp presses the stock onto the table from above (step clamp and stud, toggle clamp) or holds it from the side (side clamp, cam, small bar clamp).

Step clamp: on the left, clamp level and stud near the stock, which takes the force; on the right, block too low, clamp tilted and stud near the block: the stock is poorly held.
  • Keep the clamp roughly level: set the step block to the stock height.
  • Put the stud closer to the stock than to the block: the force goes where it is needed.
  • Tighten moderately: too tight, a clamp marks wood or bends a thin sheet; slip a scrap of wood under the pad.
  • At least two opposite clamps; one more in the middle of long stock.
  • A clamp sticks out above the stock: raise the safe height above it and check while framing that the tool passes well clear. Side clamps, lower than the top of the stock, keep the way free.
  • Keep at least one bit radius plus 5 mm between a toolpath and a clamp.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.