Skip to content

Workholding

Machinable brads

Plastic brads driven with a nailer through the stock into the spoilboard hold it with nothing sticking out, and a bit that hits one cuts it without damage.

Plastic (or composite) brads, driven with a nailer through the stock into the spoilboard, hold it without sticking out of the surface. A bit that hits one cuts it without damage, unlike a steel nail.

Brads (white) driven into the waste on either side of the cut: they go through the stock and hold in the spoilboard.
  • Drive them into the waste, and near the cut-out parts to hold them until the end; avoid finishing passes (a cut brad leaves a mark).
  • The stock must be thick enough for the brad length, and the spoilboard soft enough to hold them (MDF, plywood).
  • To separate the parts, spindle stopped, gently pry with a wood chisel, blade pointing away from you; brad remains sand off.
  • Never steel nails or staples: hit by the bit, they break it and fly off in fragments.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.