Workholding
Choosing and checking
What good workholding does, a table comparing the methods by use and limits, and five checks before the first cut: shake, draw, safe height, frame, slow start.
Good workholding:
- holds the stock in every direction, including against being pulled up (an up-cut bit lifts the material);
- stays clear of the toolpaths and below the safe height: the bit must never meet a clamp, a screw or a brad, cutting or in a rapid move (see Heights and rapid moves);
- keeps the part held until the end: a part that breaks free spins with the bit; plan tabs (see Through cuts);
- does not damage the part: a wooden pad under a clamp avoids marks;
- is easy to repeat for a series (see Jigs).
| Method | Suits | Limits |
|---|---|---|
| Screws into the spoilboard | Thick or large stock, through cuts, strong forces | Holes in the waste; screws to keep away from the toolpaths |
| Clamps | Rigid stock of even thickness, quick changes | Bulk above the stock; safe height to raise |
| Double-sided tape | Thin sheets, small parts, engraving | Little side force; the glue gives way with heat or dust |
| Masking tape and cyanoacrylate | Thin or small parts, whole surface free | Curing time; glue to handle with care |
| Jigs and stops | Series, identical parts, flipping | Jig to make, often on the CNC itself |
| Machinable brads | Wood, through cuts, saving space | Nailer and plastic brads; brads to keep out of finishing passes |
| Vacuum table | Flat panels, series | Equipment; leaks; small parts that let go at the end of the cut |
| Vise | Blocks, thick parts, soft metals | Limited area; jaws to avoid; vise to fix square |
| Tabs and thin last pass | Every through cut | Bridges to cut and sand afterwards |
Before starting:
- Shake the stock by hand, spindle stopped: it must neither slide nor tilt.
- If useful, draw the clamps, screws and jaws on a tool layer (T1, never machined): you see on the canvas that no toolpath runs over them.
- Set the safe height above the highest point of the clamps; if there are some between the shapes, turn off the fast retract (see Travel heights).
- Frame the job (the tool goes around, spindle stopped) and watch it pass well clear of the clamps, then do a dry run above the stock (see Running a job).
- Start with the feed reduced (50%), stay by the machine, a hand near STOP.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.