Skip to content

Concepts

Heights and rapid moves

Why rapid moves need a safe height above every clamp, what the fast retract between shapes does, and what the pre-send check cannot see.

Good path (blue): rapid move at the safe height (gray dashed), above the clamp, plunge, cut, retract. Bad (red): a rapid too low goes through the clamp.
  • Between two cuts, the bit travels in rapid (G0), at the machine’s top speed: it must be high enough not to hit anything.
  • The safe height, above the top of the stock, must clear the highest clamp, screw or clamping head. From one shape to the next, the fast retract only lifts a few millimeters: turn it off if something sticks out above the stock between shapes (see Travel heights).
  • The pre-send check refuses a rapid below the stock surface, but it does not know your clamps: framing checks that (see Workholding).

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.