Concepts
Origin, zeros and coordinates
Machine coordinates and machine zero, the work zero you set on the stock, the project origin that matches it, and why the Z zero sets every depth.
- Machine coordinates: the tool position within the machine travel, from its machine zero, found by homing on the limit switches when the machine has them.
- Work zero: the point chosen on the stock (a corner, the center) and the reference height (the top of the stock or the spoilboard). Dusty’s G-code is written in this frame; the controller keeps the offset between the two (
G54). - The project origin says which point of the drawing matches the work zero: the tool tip must be exactly there when you set the zero (see Origin and Z zero and Work zero).
- The Z zero sets every depth: 1 mm too high, each pass cuts 1 mm less; too low, the bit enters the material in a rapid move. Take it with a probe plate when possible (see Probing).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.