Skip to content

The project

Origin and Z zero

Which corner of the stock is the origin, why the bottom of the canvas is the front of the machine, and when to take Z zero on the stock or on the spoilboard.

The origin is the point of the stock where you will place the tool before setting X and Y zero on the machine; it is marked with a cross on the canvas, and every position shown (inspector, status bar) is measured from it. The bottom of the canvas is the front of the machine: “bottom left corner” is the front left corner of the stock.

The Z zero sets the reference of the depths:

  • Top of stock (the most common): the tool tip just touches the top of the part. A 3 mm depth goes 3 mm below the surface, whatever the real thickness.
  • Bottom of stock (spoilboard): the tip just touches the spoilboard next to the part. Useful when the stock thickness varies: a through cut always stops at the same level. The thickness you enter must then be exact.

An inaccurate Z zero cuts into the spoilboard or leaves the part attached: set it carefully, preferably by probing.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.