The machine
Probing
Set the zero with a Z plate or an XYZ block wired to the controller: position, values, a fast then slow touch, and what alarms 4 and 5 mean.
Probing sets the zero with a conductive plate or block wired to the controller: the tool goes down until it makes electrical contact. Position › Probing… (or Machine › Probing…) opens the assistant:
- Probe: Z plate (laid on the stock: Z zero on the top of the stock, plate thickness subtracted) or XYZ block (laid on the front left corner of the stock: X, Y and Z origin on that corner, then carried over to the project origin, even if it is another corner or the center). Axes to probe: Z is always probed before X and Y.
- Position: with the built-in jog, bring the bit about 10 mm above the plate (or the block, near its inner corner); for X and Y, enter the tool diameter.
- Values: thicknesses, search distances, fast and precise speeds, precise distance, back-off — taken from the machine and kept for it.
- Probing: Probe Z (axis by axis) or Probe All; a fast approach then a slow second touch give a precise contact. At the end, Origin set and the values found.
Before starting: clip on the bit, cable plugged in, spindle off; begin with a fast probing speed below 200 mm/min. If the project’s Z zero is on the spoilboard, Dusty lowers the origin by the stock thickness.
A failure stops probing: alarm 4 (the probe was already touching at the start) or alarm 5 (no contact within the search distance). Unlock, move the tool clear, check the clip and the cable, then Try Again.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.