Skip to content

The machine

Controller settings

Read and write the GRBL $$ settings with before and after shown, automatic backups and the original settings kept, restore, and resets under confirmation.

Machine › Machine Settings… (machine connected; a window on Mac, a sheet on iPad): the settings read from the controller ($$), with their name, unit and editable value.

  • Change the values, then Write Changes: only the changed settings are sent, after your agreement (“before → after”); everything is then read back and backed up. Discard Changes goes back to the values read.
  • Manufacturer Settings (steps per millimeter, inversions, homing direction…): folded behind a warning. A mistake can drive the machine hard into its stops.
  • Read Again, Save to a File…, Load a File… (the writes are prepared, then confirmed the same way).
  • Automatic Backups…: one backup at each read that changes something (20 kept per machine), plus the original settings, never deleted. Restore… only writes what differs, after your agreement.
  • Reset ($RST=$ settings, $RST=# offsets, $RST=* everything), under confirmation; resetting the settings requires the manufacturer section to be unfolded (in Dusty Studio: “I want to change the manufacturer settings” checked) and settings already read, hence backed up. Refused during a job or a motion; the console itself always refuses $RST.

A value suggested by the My Machining Is… assistant arrives here as a change to write.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.