The machine
Position check
Detect lost steps by probing a block fixed to the table before and after the job, compare against a threshold, and get advice on accelerations and belts.
A machine that loses steps (acceleration too high, loose belt, too much load) keeps believing the tool is where it should be: the rest of the job is shifted. The position check detects it with the probe block or plate fixed to the table (it must not move between the two measurements).
- Before the job: bring the tool above the block, as for probing, then Measure Reference…: Dusty probes the block (Z, then X and Y with an XYZ block, from the machine’s probe) without setting an origin and keeps its corner, in machine coordinates.
- After the job, without homing again: Check Position…: the machine rises to the top of its travel, returns above the block (machine coordinates: homing done at the start) and probes it again.
- Dusty compares: position correct (deviation under the threshold, 0.1 mm by default), or deviation beyond the threshold, axis by axis, with advice: home and redo the zero before the next job, reduce the accelerations (
$120to$122) and rates ($110to$112), check belts, pulleys, couplers and rails.
Each measurement asks for your consent (the machine moves on its own) and is refused with the spindle running, the machine not idle or the position not read back yet. The reference is kept until Dusty is closed.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.