Skip to content

Dusty Manual

My Machining Is…

Start from what you see — burnt edges, rough finish, broken bit, wrong dimensions, steps, alarms — and get the likely causes, the checks to make and the settings to change.

The My Machining Is… assistant starts from what you observe to find the cause. It opens from Help › My Machining Is…, Machine › My Machining Is…, the More menu on iPad, or Understand and Fix… on an incident card. In Dusty Studio and the desktop app: Help › My Machining Is…, or Understand and Fix… on an incident card of the Machine tab; actions on the machine lead to the Machine tab (controller settings, probing, homing), with a message saying what to open.

  1. Symptom: the edges are burnt, the finish is rough, the bit broke, the part was torn out or moved, the dimensions are wrong, there are steps in the pockets, a pocket was not machined, everything shifted during machining, the contours do not close, the depth is wrong, the part is offset on the stock, the tool hit a clamp or the stock, the job stops partway, the machine stops in alarm, the connection is lost.
  2. Questions: two or three, one at a time, with a way back; Show the Diagnosis Now skips the remaining ones.
  3. Diagnosis: the likely and possible causes, each with its explanation, what Dusty saw, the checks to make and actions; unlikely causes are folded away.

Dusty relies on what it knows: the project’s machine, the settings read from the controller, the last job in the log (or the incident received), the operation concerned and the material (chosen in the “What Dusty Knows” section), to put figures on its explanations (“0.008 mm chip for 0.05 mm recommended”). Without any of that, it reasons from your answers alone.

Actions lead to the right place: feeds and speeds calculator, recommended feeds applied to the operation (an undoable action), operation opened on the right parameter, tabs turned on, tool library, log, controller settings with the suggested value (written only after “Write Changes” and your agreement), machine settings or its G-code blocks, synchronous streaming, homing, Z zero probing, tool length sensor, preview, framing, project setup, surfacing the spoilboard, and a list of mechanical checks to tick off (machine unplugged: rails, backlash, loose parts, belts, table, speed). The assistant never acts on the machine by itself.

Connection symptoms and questions about alarm codes are only offered for a machine that Dusty drives; $ settings are only mentioned for the GRBL family.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.