Tools & feeds
The right bit, the right feed, from the first cut
Each project keeps its own copy of its tools, so it machines the same way anywhere, and the calculator suggests cautious feeds and speeds for your material and machine.
In detail
Your bits
- Six tool geometries End mill, ball mill, V-bit, drill, round-over and scribe; each operation only accepts the geometries that suit it.
- A live silhouette The tool’s outline is redrawn as you enter its diameter, flute length, number of flutes, corner radius, angle or tip.
- Spec sheet and notes Vendor, tool number, a link to the maker’s spec sheet, and free notes on materials tried or sharpening.
- Tools travel with projects Each project keeps its own copy of its tools: it machines the same way on another computer, even if your library changes.
Tool library
- A starter library 14 tools in 5 categories — end mills from 1 to 6 mm, V-bits, ball mills, a 25 mm surfacing bit, drills — with cautious feeds.
- Categories and search Sort your bits into categories and find any of them by name, whatever the case or the accents.
- Library and project Add a library tool to the project, or copy a project tool back to the library, in one click.
- Libraries as files Libraries kept in .dustytools files, to create, open or share; changes only count once you click OK.
Feeds and speeds
- Calculator by material Softwood, hardwood, plywood, MDF, acrylic, HDPE, aluminum or foam, with the radial engagement of the cut.
- Your machine considered Machine class, spindle speed range, power and maximum feed are read from the active machine, or a 3018 by default.
- A clear verdict Green, orange or red, explained, with spindle speed, feed, plunge and ramp rates, depth per pass, chip load and power needed.
- Chip load in sight Every tool and operation shows its chip load — feed divided by spindle speed times flutes — to compare with the maker’s figure.
- Spindle advance for drills How far the drill goes down at each spindle turn: 0.025 mm at 300 mm/min and 12,000 rpm.
- Signs of bad feeds A built-in reminder of what feeds depend on, and of what rubbing, burnt wood, chatter or breakage are telling you.
In the manual
-
Cutting tools
The router bits of a project and their dimensions, the tool library with its starter set, and the calculator that suggests feeds and speeds by material.
-
Tool library
Keep your bits in categories in a .dustytools library, copy them to and from the project, and start from 14 tools with cautious feeds for a desktop CNC.
-
Feeds and speeds calculator
Suggested spindle speed, feed rate, plunge, depth per pass and chip load for your material, engagement and machine, with a green, orange or red verdict.
-
Feed, speed and chip load
Feed, spindle speed and number of flutes give the chip load: the formula, a worked example, and what happens when the chip is too thin or too thick.
Explore the other features
- Drawing & text Draw exactly what the bit will cut
- Toolpaths Tell Dusty how to cut; it computes every toolpath
- 3D preview & checks See the part before the first chip flies
- Machine control Your CNC connected, zeroed and under control
- Workholding & safety Stock that stays put, a workshop that stays safe
- G-code & post-processors G-code written for your controller, in its own dialect
- Files & projects Your drawings open, your setup follows you
All this, for €0.
Every feature on this page is included, on every platform, for everyone.