Workholding & safety
Stock that stays put, a workshop that stays safe
A bit pulls and pushes at every turn. The workholding guide shows how to hold the stock, and no-go zones keep the tool away from your clamps and vise.
In detail
Workholding guide
- Nine methods compared Screws, clamps, double-sided tape, tape and glue, jigs, plastic brads, vacuum table, vise and tabs: what each suits, and its limits.
- Check before starting Shake the stock, draw the clamps on a tool layer, raise the safe height, frame the job, then do a dry run.
- Jigs for series Three contact points, a jig cut on the machine itself, the work zero saved as a position: change the part, not the zero.
- Through cuts held Tabs or a thin last pass keep the part in place until the end, with holes and inner details cut first.
No-go zones
- Clamps and vise drawn Project zones for this job’s clamps, machine zones for the vise or a fixed jig, each with the height the tool may fly over.
- The whole path checked Rapids, cuts, arcs and helixes checked against each zone, enlarged by the tool radius and a margin.
- Wherever the tool moves Pre-send check, start, framing, dry run, jog, Go to, saved positions, macros, console, resume and jobs sent to Dusty Link.
- Never a false OK Three answers only — checked, refused or cannot be checked — and “cannot be checked” blocks too.
Stops and incidents
- STOP always in sight The red button and ⌘. (Ctrl+. on Windows and Linux) reset the controller at once: motion, job, spindle and coolant stopped.
- Pause with retract The tool rises and the spindle stops, to inspect or clear chips; resuming always asks for your agreement.
- Controlled stop Stop Job brings the machine to rest, keeps its position and turns the spindle off; the job can then be resumed.
- Incident cards Each alarm or error explained by what the machine was doing, with steps to check and one-click actions that never start the spindle.
Safeguards
- Nothing starts alone Explicit agreement before any spindle start, job start or resume; macros and console commands are checked before sending.
- Lost link handled If the cable or the power goes, Dusty stops what can be stopped; continuous jog stops if the interface stops responding.
- Sleep-proof start Starting a job is ignored while the screen sleeps and for 3 seconds after it wakes, so a wake-up key never starts the machine.
- Laser mode flagged GRBL’s laser mode ($32=1) is reported as blocking for a router, and fixed after your agreement.
- Safety reminders Glasses, hearing protection, dust extraction, hands out of the work area, and never a job left unattended.
In the manual
-
Workholding
How to hold the stock down on a desktop CNC: screws, clamps, tape, glue, jigs, brads, vacuum and vise, their limits, and what to check before starting.
-
No-go zones
Mark clamps and the vise as zones with a height: Dusty checks the whole toolpath, jogs and macros against them, and blocks what it cannot check.
-
Pause, stop and STOP
The difference between pause, pause with retract, stop job and STOP, their shortcuts, and what to do after an alarm 3 when the position is lost.
-
Safety
The rules that protect you at a desktop CNC — spindle, eyes, hands, workholding, STOP and emergency stop — and the safeguards Dusty adds on its own.
Explore the other features
- Drawing & text Draw exactly what the bit will cut
- Toolpaths Tell Dusty how to cut; it computes every toolpath
- Tools & feeds The right bit, the right feed, from the first cut
- 3D preview & checks See the part before the first chip flies
- Machine control Your CNC connected, zeroed and under control
- G-code & post-processors G-code written for your controller, in its own dialect
- Files & projects Your drawings open, your setup follows you
All this, for €0.
Every feature on this page is included, on every platform, for everyone.