Skip to content

The machine

Resuming an interrupted job

An interrupted job is kept on disk: resume at the start of the pass or at the exact line, with heights and a resume program checked like a new job.

An interrupted job (stop, lost connection, alarm, Dusty closed) is kept on disk. The Job section shows Interrupted job: file, lines done, cause, and two buttons:

  • Resume… opens the resume sheet:
    • Resume Point: at the start of the pass (recommended: the tool starts again from a point outside the material) or at the exact line of the G-code (suggested line shown; Dusty goes back by the size of the controller’s buffer, without ever going back over a tool change);
    • Heights: safe height, top of stock, feed for going back down, spindle delay, suggested from the project when the job was started;
    • the computed resume program: line, position of the resume point, remaining lines, points to check;
    • Prepare Resume… then opens the pre-send check and the confirmation of an ordinary job.
  • Forget abandons the job (after a confirmation: resuming will no longer be possible).

Resuming is refused if the position is lost: home the machine first (the work zero is kept by the controller). On a machine without homing, check “I have set the work zero again (XY and Z)” after doing so. Before resuming: right tool fitted, work zero unchanged, stock and clamps in place.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.