Skip to content

The machine

Console

Send commands to the controller and read its answers, with the full console, a cheat sheet of GRBL commands and a confirmation before any spindle start.

The Console section shows the latest exchanges and accepts a command ($$, $I, G0 Z10…), sent with Return. Full Console… (Machine › Console) shows everything since the connection; Show all adds the status reports, acknowledgements and job lines.

A command that starts the spindle (M3, M4) or resumes a program (~) first asks for your agreement. To clear settings, use the reset of the controller settings.

Cheat sheet (button to the left of the field; Studio: Command cheat sheet under the field): a click puts the command in the field without sending it (Return sends it).

CommandWhat it does
$IController information: version, options, buffer size.
$$All settings ($0 to $132…).
$#Offsets: G54 to G59 coordinate systems, G28, G30, G92, tool length, last probe.
$GParser state: active modes (G54, G90, G21, M5…).
?Immediate status report: state, positions, feed, spindle.
$XUnlocks after an alarm, without homing: the position is not guaranteed.
$HHomes all axes (limit switches required).
$HX, $HY, $HZHomes a single axis, if the controller accepts it.
$n=vWrites a setting ($110=2000); prefer Controller settings, which checks the value.
$CCheck mode: G-code is read without moving; send it again to leave.
$NLines run each time the controller starts.
$J=Jog, for example $J=G91 X10 F1000 (10 mm along X).
$SLPSleep: spindle and coolant off, reset to wake up.

With grblHAL, $ES reads the setting descriptions; with FluidNC, $SD/List lists the SD card.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.