Skip to content

The machine

Spindle, accessories and overrides

Start the spindle at a set speed, turn coolant and vacuum on or off, and adjust the feed, spindle and rapid overrides while the job runs.

  • Spindle: Speed (in rpm, at most the spindle speed at S max of the profile; Dusty converts it into an S value as for jobs), then Start… (always confirmed: “The Spindle Will Turn”); Stop turns off the spindle and the accessories. On a machine whose spindle is started by hand (router), set the speed on the tool and start it yourself: Dusty reminds you before machining.
  • Coolant: on or off.
  • Vacuum: on or off, if the machine profile has a vacuum (accessories: on and off commands, M7 and M9 by default, or those of your relay). Only when idle: disabled in alarm and during a running job (the job controls the vacuum itself). The state comes from the controller report when the command is M7 or M8, otherwise from the last command sent.
  • Overrides, immediate effect during the job: Feed and Spindle (−10%, +10%, back to 100%), Rapids (25, 50 or 100%). The value shown is the one the controller reports.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.