Skip to content

The machine

Go to

Send the tool to exact work or machine coordinates along a safe path checked against the travel, or to the reference point of the selection.

Go to section of the Machine panel: bring the tool to precise coordinates.

  1. Coordinates: Work (the work zero) or Machine (machine coordinates).
  2. X, Y, Z: an axis left empty stays unchanged. Read Position fills the three axes (or one, from its menu) with the current tool position in the chosen coordinates.
  3. Go…: after your agreement (the target is recalled), if X or Y changes, the tool first rises to the top of the travel (just below the Z switch), moves in X and Y, then descends to the entered Z; without an entered Z, it stays at the top. A Z alone is done directly. Speeds: those of the jog.

Every move is checked against the machine travel before it starts: homing is therefore required, and a target outside the travel is refused with the reason (axis, value, limits). Nothing starts either if the machine is not idle. Stop the move (central jog button, or Esc) interrupts it.

  • Machine → Selection: sends the tool above the reference point of the selection (the one of the inspector: center, corner…), Z at the top of the travel, after your agreement.
  • Selection → Machine: places the reference point of the selection at the current tool position (work coordinates); undoable like any move.
  • Tool Position on the Drawing: an orange crosshair shows the last known tool position on the canvas, kept after disconnecting.

Work coordinates match those of the drawing when the work zero is set at the project origin.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.