The machine
Machine settings
Every section of a machine profile: travel and machine zero, connection, controller and streaming, spindle S value, post-processor, kinematics, accessories, probe.
Machines… › Settings… opens a copy of the profile: OK saves it (refused while a setting is inconsistent), Cancel discards it.
| Section | Settings |
|---|---|
| Machine | Name, controller units, X, Y, Z travel, machine zero corner (where the tool goes when homing), automatic detection of that corner. |
| Connection | None, USB (serial port, speed in baud; the USB port is detected at each connection), network (Telnet: IP address or name, port), HTTP network of a Duet board (address, password), FluidNC’s WebSocket (address, port 81). See Other controllers. |
| Controller | G-code flavor, DTR signal, RTS/CTS flow control, native jog ($J), regular position queries, job streaming: buffered (recommended) or synchronous (one line at a time). |
| Startup | Offer Homing When Connecting (a question, never without your agreement); pre-start checklist, one item per line, to check before each job. |
| Spindle and files | Maximum S value (setting $30; 1000 on 3018 boards, where S = rpm ÷ 10), spindle speed at max S (Dusty converts the tools’ rpm in this ratio), wait after spindle start, spindle started by hand (router), file extension. |
| Post-processor | Tool changes, automatic tool changer, dwell units, comments, block escape character, verbose output: see Post-processor options. |
| Kinematics | Maximum speeds and accelerations per axis, to estimate durations (read back from the controller). |
| Simulation | Junction deviation, minimum corner speed, simulated cutting and overall speeds (in %): they adjust the time estimate. |
| Accessories | Vacuum and coolant: present or not, on and off commands, stop when a job is interrupted. |
| Custom G-code | The blocks: see Custom G-code. |
| Probe | Z plate only or XYZ block: thicknesses, walls, search distances, speeds: see Probing. |
| Tool length sensor | See Tool length sensor. |
| Saved positions, Macros | See Positions and macros. |
| Notes | Free text. |
In Dusty Studio and the desktop app: Machine tab › Machine Settings…, with the same sections and the same behavior (a copy, OK refused while a setting or a written G-code block is in error); the probe, the tool length sensor, positions and macros have their own windows there (see Studio’s Machine tab).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.