Skip to content

The machine

Connection assistant

When the machine does not answer: ports, USB adapter driver, every speed, controller greeting and link stability are tried in turn, nothing moves, and what is missing is explained.

The machine does not answer, or you do not know which port to choose? In the Machine panel, Connection section, Connection Assistant… (machine disconnected) runs the checks one after the other and tells what is missing. Nothing moves: the assistant only reads (?, $I, $$), one port at a time.

  1. Computer ports: USB ports are kept; Bluetooth ports and the computer’s built-in ports are ignored, like the ones you excluded from auto-detection.
  2. USB adapter driver: on Windows, a CH340, CP210x or FTDI adapter plugged in without a driver is reported, with a link to the driver page of the manufacturer; on Linux, an adapter without a serial port (missing kernel module, or adapter taken by brltty); macOS recognizes these adapters out of the box.
  3. Each port, at each speed: the profile’s, then 115,200, 250,000 and 9,600 baud. A port already open in other software, a denied access (dialout group on Linux), an unreadable answer (wrong speed) or no answer at all are explained; without an answer, a last try is made without DTR. A controller from another family than GRBL (Marlin, Smoothieware, Duet over USB) is recognized; Marlin and Smoothieware are driven through their bridge (see Other controllers).
  4. Controller settings: the travel ($130 to $132) is read.
  5. Connection stability: twenty status reports requested in two seconds; if some are missing, the assistant recalls the cable rules (USB data cable, shielded, shorter than 3 m, no hub, away from the motor cables). In Dusty Studio and the desktop app, Long stability test extends it to 30 seconds (300 reports): a cable or power supply that drops out after a few seconds shows up.
  6. Catalog machine: the models with the same travel and the same controller are suggested.

At the end, Save in the Active Machine (port, speed, DTR) or Add This Model (the suggested model, with the connection found, becomes the active machine). A machine whose profile has a network address is reached at that address, then queried the same way.

In Dusty Studio (browser), the browser shows neither the list of ports nor the drivers: Choose the Port and Start opens its port chooser, then the assistant tries that port at each speed. The desktop app tries every port, like the Mac app.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.