The machine
Center finder
Find the center and diameter of a round part from three points touched with the tool, then go there safely or draw a guide circle in the project.
Machine › Center Finder… (Dusty Studio’s Machine tab: Center finder…) finds the center of a round part (or of a regular polygon, from its corners):
- With the built-in jog, bring the tool tip against the edge (with paper, without forcing), then Take point 1.
- Repeat for points 2 and 3, well spaced around the edge.
- Dusty shows the center (machine and work coordinates) and the diameter.
Go to Center brings the tool there along the safe path of Go to (Z at the top of the travel), after your agreement; then lower it with the jog and set the X and Y zero. Add a Guide Circle to the Project draws a circle of the diameter found, centered at the right place, on tool layer T1 (never machined). Start Over clears the points.
Messages: points too close (at least 5 mm between two points), points aligned (no circle goes through them: take a point again), center outside the work area (check the homing and the points).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.