The machine
Tool length sensor
A fixed probe on the table measures each new tool against a reference, so the Z zero is corrected after a tool change, by hand or during the job.
A tool length sensor is a fixed probe on the table: after a tool change, the difference between the contacts of the old and the new tool corrects the Z zero. It is set up in the machine settings:
- X and Y position of the sensor, in machine coordinates (Use the Current Tool Position when the machine being edited is connected and homed);
- start at the top of travel (below the Z switch) or at a given start height; search descent;
- approach, fast and precise speeds, precise distance, back-off.
- Length compensation: shift the work zero (
G10 L2, all controllers, kept by a reset) or tool length offset (G43.1, cleared by a controller reset, then restored by Dusty as soon as the machine is idle); - Measure Each Tool During the Job: the Tool length probe block is written at the start of the program and after each tool change (GRBL, grblHAL and FluidNC controllers driven by Dusty).
Homing is required (positions in machine coordinates); the cycle starts at the top of the travel, below the Z switch. In the custom G-code, Write from the Sensor Settings fills in the Tool length probe block.
Use (Tool Length Sensor section of the Machine panel):
- Set the work Z zero with the first tool, then Measure the Reference…: the machine rises, goes above the sensor and probes (fast then precise); this contact becomes the reference.
- After a tool change done by hand: New Tool… measures the new tool and applies its length difference with the reference (shown, “+1.500 mm” for a longer tool): no need to set Z zero again.
- During a job whose profile asks for the measurement: the starting tool is measured at the beginning (reference, or correction if it has changed), then each new tool when resuming from a tool change; the rest of the job waits for the end of the measurement.
- Without the measurement in the job: at a tool change, the prompt’s Measure New Tool… measures it before resuming.
A new Z zero (zero, probing) forgets the reference: the next measurement becomes one again. Each measurement started by hand asks for your agreement (the machine will move).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.