Skip to content

The machine

Tool table and automatic tool changer

With a grblHAL tool table and an automatic tool changer, the controller runs the M6 changes and G43 H applies each tool's offset; not yet tested on a real board.

A grblHAL controller built with a tool table keeps the length offset of each tool; with an automatic tool changer, it runs the M6 commands itself (Z up, spindle stopped, tool changed), without stopping the job.

  • Machine settings, G-code tab (Studio: G-code Options): Tool changes as M6, then Automatic Tool Changer and Controller tool table (G43 H after each M6). The G-code then applies the tool’s offset (G43 H2 after T2 M6), the starting tool included. A tool table and measuring each tool during the job contradict each other: Dusty points it out.
  • Machine panel, Tool Table section (shown when the controller reports a table): the offset of each tool, in mm more than the reference tool. Type a value (written with G10 L1, then read back), or, with a tool length sensor: first measure the reference (the tool used for the work Z zero), mount a tool (T3 M6 in the console), then Measure… on its row writes its length difference to the table (after your agreement: the machine moves).

The virtual CNC simulates such a board when the machine is a grblHAL declared with a tool changer: eight pockets, a tool table, tools of different lengths. No test has been made on a real tool-changer board yet: run the first one dry, spindle stopped, Z above the stock.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.