The machine
Tool change
At each tool change, Dusty raises Z, stops the spindle and guides you: mount the tool, set Z zero again or measure it with the sensor, then resume.
When a job uses several tools, the program stops at each tool change (GRBL 1.1 cannot change tools by itself). Before inviting you to change the tool, Dusty makes the machine safe: it waits for the moves to end, raises Z to the top of travel (below the switch, once the machine is homed; without homing, by the lift of a pause with retract), stops the spindle and coolant, then checks on a status report that the machine is idle with the spindle stopped. Only then does the prompt appear in the Job section:
- the title (“Tool change: tool #2”) and the program message (tool name);
- the steps: spindle stopped and Z raised; mount tool #…, tighten the collet, remove the wrench; take its length into account; resume;
- a warning as long as the new tool’s length is neither measured nor compensated.
How the new tool’s length is taken into account depends on the machine:
| Machine | What the prompt says |
|---|---|
| Without a tool length sensor | Set Z zero again with the new tool: jog and Z zero, or probing with the plate. Do not touch the X and Y zero. |
| With a sensor | Measure New Tool… (after your agreement: the machine goes above the sensor and probes, spindle stopped). The difference from the reference corrects the Z zero; the prompt shows “New tool measured: +1.500 mm”. |
| Sensor measured during the job | Nothing to do: the new tool is measured as soon as you resume. |
| Controller tool table | Nothing to do: the job applies the tool’s offset (G43 H). |
Resume… asks for your agreement: “Tool #2 mounted and tightened, wrench removed? The spindle will restart and the job resume”, followed by the warning if something is left to do. The machine goes back above the stop point at the top-of-travel height; if the spindle was stopped out of the material (a tool change made at the safe height), the tool stays there and the program positions it itself; otherwise it comes back down, slowly into the material. Resuming follows the work frame as it is when you resume: zero set again or length applied during the stop.
A program stop (M0 in the program) is resumed the same way, without raising Z. A grblHAL or FluidNC controller that announces it can change tools receives the M6 and handles the change itself (see Tool table and automatic tool changer); otherwise, Dusty stops as for GRBL 1.1.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.