Skip to content

The machine

Adding a machine

Add your CNC with Find My Machine, the catalog of 67 commercial models or a GRBL profile to set up, then check its travel, origin corner and spindle.

The Dusty tour chooses the machine at first launch. If you skipped it, the Machine panel offers Add a Machine…, which reopens it on these steps:

  1. Which machine do you have? The preset 3018 CNC, Find My Machine, A Machine from the Catalog, or No Machine Yet (a dummy machine with no link, to draw and prepare; the virtual CNC stays available).
  2. Let’s find your machine: Dusty tries the USB ports (on Mac) and looks for Dusty Link on the network; it only reads, nothing moves. It offers the models that match the controller it found. Otherwise, type its Wi-Fi address, choose it from the catalog, or import a starter package from another Dusty installation (settings and machines), or an exported profile.
  3. Choose your machine: the maker, then the model; My Machine Is Not Listed gives a GRBL profile to set up.
  4. Your machine: check its travel, the corner of its origin and its spindle. The profile is saved when you continue; everything else is set later in the machine settings.

For a less common machine or every setting at once, Machines… › + opens the New Machine assistant, which goes step by step:

  1. Model: the preset 3018 CNC (GRBL 1.1) (300 × 180 × 45 mm, over USB), a dummy machine, a commercial machine chosen in the catalog (67 models from Carbide 3D, FoxAlien, Genmitsu, Inventables, MillRight, Ooznest, OpenBuilds, Sienci, Snapmaker…) or another machine to set up from its controller’s G-code flavor. For a catalog machine, the sheet says what comes from the manufacturer’s public pages and what to check. When in doubt about the controller, choose GRBL, then type $I in the console.
  2. Connection: USB (serial port) with its speed, network (Telnet: address and port), HTTP network of a Duet board (address, password), FluidNC’s WebSocket (address, port 81), or none.
  3. Information: name, controller units, X, Y, Z travel, machine zero corner.
  4. Communication: flavor, serial signals, streaming mode, spindle.
  5. Summary, then Create Machine (with “Use This Machine”).

At each connection, Dusty reads the controller’s settings and updates the profile (travel, speeds, spindle, machine zero corner).

In Dusty Studio and the desktop app, New Machine… (Machine tab) opens the same assistant: 3018 CNC, dummy machine, commercial machine (manufacturer, then model) or generic machine (travel, spindle and controller to set), then Connection, Information, Communication and Summary. For a USB or network machine, the The machine is plugged in: run the connection assistant box chains with the connection assistant, which finds its port and speed and saves them in the new machine.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.