Skip to content

The machine

Connection

Connect to the machine or to the virtual CNC, let Dusty read the controller settings, fix those that differ — GRBL laser mode included — and reconnect after a loss.

In the Machine panel, Connection section:

  1. Choose the machine (the active machine).
  2. Connection: Virtual CNC (built into Dusty) or Machine (the connection of its profile: USB or network). A machine without a connection can only be reached through the virtual CNC.
  3. Connect. Dusty opens the port (the most likely USB port is chosen automatically: CH340, FTDI, CP210x chips…), waits for the controller’s welcome message, reads its settings, updates the profile (travel, speeds, spindle) and reports what remains to be checked. Unsure of the port or the speed: Connection Assistant… (see Connection assistant).

Once connected: the section shrinks to the machine, Disconnect, Reconnect (the port is detected again, also with Machine › Reconnect, ⌃⌘R) and Machine Settings…. If the machine asks for it in its settings, Dusty offers homing as soon as it is ready (“Home the machine?”: nothing moves without your agreement).

Auto-Detection… (under the port choice) excludes from auto-detection a port that is not the machine (another USB device, a 3D printer): it is never picked automatically again, but stays in the list. The setting applies to all machines; Include … Again puts it back. Disconnecting waits for the end of the running job; STOP is always possible.

Settings to Check

If the settings read differ from the profile, the panel lists them with their fix. GRBL’s laser mode ($32=1) is blocking for a milling machine (it would let the spindle slow down during moves): Write $32=0 fixes it after your agreement. For the maximum spindle speed or the travel, Align Profile with Machine takes the controller’s values.

If the connection is lost (cable unplugged, machine switched off), Dusty says so, stops what can be stopped and offers to reconnect. A controller that no longer responds is reported (“check the cable and the power supply”).

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.