Skip to content

The machine

Dimension calibration

Cut a test piece, measure it with a caliper, and get the scale of each axis, the effective tool diameter, the squareness and new steps per mm to write.

Machine › Dimension Calibration… (Dusty Studio’s Machine tab: Calibration…) checks that the machine cuts to the right dimensions and proposes corrections:

  1. Test piece: a raised square (40 mm by default) surrounded by a groove wide enough for the caliper jaws, with a square pocket in the middle (20 mm), 2 mm deep. Set the tool, feeds and spindle, then Open as Program: the piece is sent like any G-code program, with the pre-flight check and your consent (the spindle runs). Origin at the front left corner of the stock, Z zero on top of the stock; the stock size needed is shown.
  2. Measurements with a caliper: width of the boss and of the pocket in X and Y, both diagonals of the boss, depth of the pocket. Not all are required.
  3. Corrections: the scale of each axis comes from the sum boss + pocket (the real tool diameter cancels out); the effective tool diameter from their difference (to enter in the tool library); the squareness from the diagonals (angle and mm over 100 mm); the depth deviation. For a connected GRBL-family controller, Write Steps per mm… proposes the new $100 and $101 (vendor settings), shown before → after, written after your consent. Then cut the test piece again to check.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.