The project
Project setup
The Project Setup page and its stock diagram: stock size, XY origin, Z zero, heights, cut order, units and machine, applied together with OK.
File › Project Setup… (⌥⌘,) gathers every setting on one page, with a stock diagram: top view with the origin and the axes (X to the right, Y toward the back of the machine), side view with the Z zero. The settings are applied together with OK, as a single action that ⌘Z undoes; Cancel discards them.
| Setting | Purpose |
|---|---|
| Stock: width (X), depth (Y), thickness (Z) | Size of the material; the canvas work area takes this size. 300 × 200 × 18 mm by default. |
| XY origin | Corner of the stock (bottom left, bottom right, top left, top right) or center, where you will set X and Y zero. |
| Z zero | Top of stock, or bottom of stock (the spoilboard). |
| On the Machine | The steps to carry the origin and the Z zero over to the machine. |
| Heights | Safe height, fast retract between shapes, pocket lift: see Travel heights. |
| Cut order | Repeated parts machined operation by operation or part by part: see Cut order of repeats. |
| Units | Millimeters or inches, for display and input; Dusty always computes in millimeters. |
| Machine | The active machine, whose G-code flavor and travel are used for export and for the pre-send check. |
For a new project, the same page opens under the title New Project, with your recent projects on Mac (on iPad, the system file browser plays that role). Settings › Project › “Set up each new project” turns it off.
The Project panel of the inspector repeats the stock, origin, heights and units: each change applies at once (and is undone with ⌘Z). Problems (zero size, inconsistent height) are shown below the settings.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.