Skip to content

Concepts

Router bits

Flat end mills (up-cut, down-cut, compression), ball nose bits, V-bits and drill bits: what each one is for, and why the cutting diameter must be exact.

From left to right: flat end mill, ball nose, V-bit, drill bit.
  • Flat end mill: profiles, pockets, slots. Its flutes lift the chips (up-cut: good evacuation, but it raises the top fibers) or push them down (down-cut: clean top, to avoid at the bottom of a deep slot); a compression bit does both, for plywood.
  • Ball nose: rounded bottoms and relief finishing.
  • V-bit: crisp lines and letters; the line width depends on the depth (V-carving, chamfer).
  • Drill bit: a hole at the drill’s diameter, by plunging only (drilling).

The cutting diameter places the toolpath: it must be exact in the project tools. A long bit deflects more: prefer the shortest one that reaches the depth you need.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.