Skip to content

Cutting tools

Project tools

The project keeps its own copy of each bit: geometries, live silhouette, dimensions, feeds and speeds, chip load, spec sheet link and notes.

The Tools panel lists the bits of the project. The project keeps its own copy of each tool: it will machine the same way on another computer, even if your library changes.

  • Add Tool: a new tool of a geometry, or From Library.
  • Geometries: end mill, ball mill, V-bit, drill, round-over, scribe. Each operation type only accepts some geometries (a pocket refuses a V-bit, a chamfer requires a V-bit…).
  • Editor: name (empty: a name built from the geometry and the diameter), geometry, units, number (tool changer), vendor, link to the spec sheet, notes; a silhouette of the tool updated live; the dimensions for its geometry (diameter, flute length, number of flutes, corner radius, included angle, tip radius or length); the feeds and speeds (feed rate, plunge, ramp, spindle speed, depth per pass, stepover) and the resulting chip load.
  • Spec sheet: an http or https link (or an address such as www.example.com/bit, completed with https://) shows Open the Spec Sheet, which opens it in the browser; any other text is not opened. The notes freely keep references, materials tried, sharpening…
  • Spindle advance (drills): below the feeds, how far the drill goes down during one spindle revolution, plunge rate ÷ spindle speed (300 mm/min at 12,000 rpm: 0.025 mm per revolution). Compare it with the feed per revolution recommended by the manufacturer.
  • What feeds and speeds should I use?: a collapsed box, in a tool’s editor and in an operation’s editor, recalls what feeds depend on, the signs of badly set feeds (bit rubbing and heating, burnt wood, chatter, breakage) and gives links to public pages (Wikipedia, CNC Cookbook).
  • A tool’s feeds are copied into an operation when it chooses the tool; they then belong to the operation. After changing a tool’s feeds, choose it again in the operation to take them over.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.