Skip to content

Preview

Pre-send check

What Dusty refuses before every send — rapids through material, toolpaths beyond the travel, no work zero, zero feed — and the warnings left to you.

Before every send, Dusty reads the program again. In the preview, the Pre-send Check section shows what it finds without a machine; the same check, completed with the machine (work zero and travel), appears when you start the job.

Blocking (sending is refused):

  • the safe height is not above the stock;
  • a rapid move goes through the material (Dusty takes into account the material already removed by earlier cuts of the same job);
  • the toolpath leaves the machine travel;
  • the work zero is not set (checked when sending);
  • a tool is not defined, a feed rate is zero, the spindle is stopped during a cut, or there is nothing to machine.

Warnings (you decide): feed rate beyond the machine maximum (the controller will cap it), tool going below the stock (into the spoilboard), toolpath leaving the stock (clamps!), spindle to start by hand.

Then come the problems of the operations themselves (open shape, unsuitable tool…), preceded by the operation name.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.