Skip to content

Preview

Preview troubleshooting

Answers to the usual questions in the preview: 3D check alerts, a wrong estimated time, a part that differs, shapes not machined, rounded inside corners.

The Troubleshooting section, at the bottom of the preview, gathers the usual questions; those about the project or the last check come first, marked Check this:

  • 3D check alerts: collision → let the tool stick out further from the collet, use a tool with a longer cutting length or cut less deep; rapid move through material → raise the safe height; plunge too fast → lower the plunge rate or enter with a ramp; air cutting → lower the retract height, check the stock thickness and the Z zero.
  • The estimated time is wrong: the estimate follows the active machine (speed and acceleration of each axis, slowing down in corners); choose the right machine, read its settings from the controller or correct its simulation speed factors; the machining log then refines the estimate.
  • The machined part does not look like the preview: check the clamping (the stock did not move), the tool (tight, sticking out enough), the axes (lost steps), the feeds advised by the tool maker, and that the mounted tool is the operation’s tool.
  • Some shapes are not machined: a tool that is too large does not fit into the narrow parts of a pocket or between two close contours; use a smaller tool or add a rest pocket.
  • Inside corners are rounded: a round bit leaves a radius of half its diameter in every inside corner; rest pocket with a smaller tool, or dogbones for joinery.
  • See a cut-out part without its offcuts: double-click the piece to hide (see Machined part).

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.