Preview
3D check
A background check of every move against the material left: tool holder and shank collisions, rapids through material, plunges too fast and air cutting.
Each time the preview opens, Dusty checks the job in 3D, in the background: it carves the simulated part move by move, like the machined part, and checks each move against the material left just before it. The 3D Check section shows the progress (Cancel stops it; what is already checked stays shown), then the summary and the findings:
- Tool holder collision (danger): the collet nut or the spindle nose, above the tool stick-out, goes into the material — a pocket deeper than the tool sticks out, for example;
- Tool shank collision (danger): the non-cutting part of the tool, above its cutting length, rubs the material — a small end mill on a 3.175 mm shank going deeper than its flutes;
- Rapid move through material (danger): a rapid move goes through material still in place;
- Plunge too fast (warning): a feed move down into the material whose vertical speed is more than 10 % above the tool’s plunge rate (the library’s) or, for an unknown tool (opened G-code file), half the operation’s highest lateral feed; a gentle ramp passes;
- Air cutting (information): a run of moves at cutting feed that remove nothing, from an adjustable length (5 mm by default); the summary gives the share of the cutting time spent in the air, approach descents included.
Each finding gives the G-code line (of the file sent to the machine, or of the opened G-code file), the operation, the position of the tool tip and the time; a click puts the cursor at that time: the views show the tool where the problem is. On the top view, each finding is marked with a red (danger), orange (warning) or blue (information) diamond.
Check settings
Detail of the checked part (normal by default), Tool holder diameter (20 mm by default: an ER11 collet nut with some margin), Tool stick-out (20 mm by default, from the tip to the collet nose; at least each tool’s cutting length plus 2 mm) and the length from which air cutting is reported. They are kept; Check Again runs the check again with them.
Good to know:
- The cutting length comes from the operation’s tool; its shank is assumed to be its cutting diameter, and at least 3.175 mm. For an opened G-code file the tools are unknown: the tool holder, rapids, plunges and air cutting are checked, not the shank.
- The check follows a 3-axis machine at the chosen resolution, without refinement: a move that removes less than one grid step along a wall counts as a move that cuts (a finishing pass is never taken for air cutting), and contacts of less than 0.05 mm are ignored. A move is judged as a whole: if part of it cuts, it is not in the air.
- Clamps and the spoilboard are not modeled.
- The computation runs off the interface (in slices in Dusty Studio and the desktop app); closing the preview stops it.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.