Workholding
Masking tape and cyanoacrylate glue
Masking tape on the spoilboard and under the stock, a few dots of super glue in between: a very strong hold that peels off cleanly, with its precautions.
A very strong variant of taping: a strip of masking tape on the spoilboard, another under the stock, and a few dots of cyanoacrylate glue (“super glue”) in between. The tape then peels off cleanly: neither the part nor the spoilboard keeps any glue.
- Masking tape smoothed well on the spoilboard and under the stock, strips edge to edge, without bubbles.
- A few dots or a bead of glue on one of the tapes; an activator sprayed on the other speeds up curing.
- Lay down, press for 10 to 30 seconds, then wait for the full cure given by the maker before starting.
- After machining, spindle stopped, peel the tape slowly or slide a thin putty knife under it.
Precautions: ventilate (the fumes irritate eyes and nose), wear glasses and keep your fingers out of the glue, which bonds skin in seconds (keep the debonder recommended by the maker at hand). Glue and unglue away from the bit; gloves used for gluing come off before touching the controls or starting the machine: a glove can be caught by a turning tool.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.