Skip to content

Workholding

Vacuum table

A vacuum table holds the stock by suction: hold that depends on the area, leaks to cover, and how to switch the pump so that it never lets go mid-cut.

A vacuum table holds the stock down by suction: a pump draws the air from under the stock through a drilled or grooved plate, often covered by an MDF spoilboard that lets air through.

Section: chamber and drilled plate of the table (gray), spoilboard that lets air through, stock; the air is drawn towards the pump (right).
  • The hold depends on the area under the part: a large sheet holds very well, a small part hardly at all at the end of its cut. Keep tabs or a thin last pass for small parts.
  • Cover the free areas (waste, sheet, film): every leak costs holding force.
  • Surface the spoilboard from time to time (see Surfacing and face): a dug spoilboard leaks.
  • Switching on: plug the pump into its own switch and start it before the job. If it is wired to a controller output, have it started by the Header block of the custom G-code, followed by a dwell (G4) of a few seconds, and stopped by the Program end block, once the spindle has stopped (see Custom G-code). Do not declare it as the dust collection: Dusty may switch dust collection off when a job is interrupted, and STOP resets the controller, which turns its outputs off: the part would be released while the bit spins down.
  • A pump failure during machining releases the part: stay by the machine. After a STOP or an alarm, wait for the spindle to stop completely before coming near.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.