Skip to content

Machining operations

Surfacing and face

Flatten the spoilboard with surfacing, or the top of the stock with a face operation, using an end mill or a wide surfacing bit, in raster or offset.

Two operations to flatten, with an end mill (a wide surfacing bit goes faster):

  • Surfacing (of the spoilboard): draw a rectangle of the area to surface. The tool center runs on the outline, so the tool overhangs by half its diameter; Dusty works from the outside inward. Raster pattern by default (or offset), angle, outline pass.
  • Face (the top of the stock): raster only; Clearance beyond the shape as a % of the tool radius (0%: like a pocket, 100%: the tool center reaches the outline, 200%: the tool goes completely out), at the end of each line and on the edges.

A small depth per pass (a few tenths of a millimeter) and a stepover of 40 to 70% give a good surface. Dusty warns when the tool leaves the project work area: check the machine travel and the clamps.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.