Skip to content

Machining operations

Tabs

Leave small bridges of material so that cut-out parts stay in place: tab type, size and height, automatic placement, the Tabs tool and the tab assistant.

Tabs (holding bridges) leave small bridges of material on a through profile, so that the part does not move at the end of the cut. You cut them afterwards with a knife and sand. How many to use, and the other way to hold a cut-out part (thin last pass): see Through cuts.

Check Tabs in the “Tabs (holding bridges)” group of a profile:

  • Tab type: Partial retract (the default: the tool rises to the tab height above the bottom, only for the deeper passes), Full retract (the tool rises to the start depth over the tab), Ramp (same height, with a sloped rise and descent over the first and last quarter of the tab).
  • Tab size (5 mm by default): it is measured on the center of the tool. The bridge left is “size − tool diameter” (half of that for a ramp tab): with a 6 mm bit, use at least 8 to 10 mm. Dusty warns when almost nothing is left.
  • Tab height (2 mm by default): thickness of the bridge, above the bottom.

Placement: without tabs placed on its shapes, Dusty spreads them automatically on closed outer outlines (not on holes, whose scraps may fall), about one every 150 mm of perimeter, between 4 and 16, without covering more than a quarter of the outline. Tabs placed on a shape (by hand or by the assistant) replace this placement; they are kept in the .dusty file and are machined only if the profile’s Tabs box is checked.

  • Tabs tool (B, tool column and Drawing menu): a click on an outline places a tab there, a click on a tab removes it; a dragged tab follows the outline of its shape to its new place (Escape puts it back). Each click or drag is undone with ⌘Z.
  • Tab assistant (button in the bar of the Operations panel, Operations menu, right-click on an operation): select the shapes, then set the placement. The proposed tabs appear in green on the canvas at each change; nothing is placed before Place Tabs.
    • Even spacing: a tab at the start of each path, then one every Spacing; At least sets a minimum number of tabs per path (they move closer if needed), Limit the number of tabs a maximum.
    • Count per shape: the path is split into equal parts; on a closed shape, the first tab is shifted by half a part.
    • Skip inner shapes: a shape entirely inside another closed shape gets no tab (its scraps may fall).
    • Two tabs stay at least two tab lengths apart (that of the profiles machining these shapes, 5 mm without a profile): a small shape gets fewer.
    • Place Tabs replaces the tabs of the shapes concerned, in a single undoable action; a shape that gets no tab keeps its own. If a profile of these shapes does not have its Tabs box checked, the assistant offers to check it in the same action. Cancel (or Escape) keeps nothing.
    • The tabs placed remain adjustable with the Tabs tool.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.