Skip to content

Machining operations

Trochoidal path

Small loops that advance along the path to limit tool engagement: less load on a weak spindle, deeper passes, and a wall pass for the exact size.

For a weak spindle (3018) or a hard material (aluminum, hardwood): instead of moving straight ahead with its whole diameter engaged, the tool describes small loops that advance along the path. It bites a thin slice at the front of each loop, then comes back into the area already cleared: less load, better cooling, better chip evacuation, and a larger depth per pass becomes possible (the whole cutting length of the bit is used). Machining takes longer.

In the “Strategy” group of a profile, pocket, rest pocket or dogbone slot:

  • Tool path: Direct, Trochoidal (full circles) or Trochoidal (half circles): a half circle at the front, then a straight line to the next one; a little faster, a little more load (the first loop and those in the corners make one and a half turns).
  • Trochoidal diameter (3 mm by default): diameter of the loops followed by the center of the tool. For a profile, the slot measures trochoidal diameter + tool diameter, on the waste side.
  • Trochoidal step (0.5 mm by default): advance from one loop to the next. It limits the tool engagement: each loop only removes, beyond the previous one, a slice as thick as the step. Under this field, the editor shows the slot width (profile) and the maximum radial engagement, in mm and as a % of the diameter (a direct slot engages 100%). Start around 10 to 20% of the diameter.

What Dusty does:

  • Profile: the loops run in the waste, one loop radius away from the outline; then, at each pass, a direct wall pass follows the outline and gives the exact size (the small scallops between two loops and the inside corners) while removing almost nothing. On the line, the loops follow the path itself (centered slot, no wall pass). A hole too small for the loops is machined with the direct path (warning).
  • Pocket (and rest pocket, dogbone slot): the clearing pattern (offset or raster, at the stepover) is laid out in the area of the loop centers, then the loops follow it; at each pass, the wall (and the spurs of a dogbone slot) is finished with the direct path, except in raster without an outline pass. The trochoidal diameter is reduced to the tool diameter there (no material is left between two neighbouring loops). An area too narrow for the loops is cleared with the direct path.
  • Tabs: the loops stay above each tab across the whole width of the slot, like the direct path; the material bridge is the same.
  • Entries: plunge; zigzag ramp on the first loop; helical on the circle of the first loop, at the ramp angle, then the loop itself makes the flat turn (a ramp if a tab crosses that circle); spiral (profile): the loops go down one pass per turn, a flat turn at the bottom, then the wall in a spiral.
  • Safeguards (warnings): step reduced to the tool radius (beyond that, the load is no longer reduced); half circles changed to full circles if the trochoidal diameter exceeds the tool diameter (the straight return would cross the material at the center of the loops).
  • The loops are written as G2/G3 arcs (or as segments if the machine refuses them). The pattern thumbnail shows the loops on a sample shape, under Tool path for a profile, under Clearing pattern for a pocket.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.