Skip to content

Machining operations

Fluting

Decorative flutes with tapered ends for columns, legs and frames: the tool ramps down gradually, cuts a flat section, then ramps back up.

Decorative flutes with tapered ends (columns, legs, frames, trays, signs): the tool follows the path itself, like a profile on the line, but goes down gradually along the entry ramp, cuts at the wanted depth along the flat section, then comes back up gradually along the exit ramp. With a ball-nose bit or a V-bit, the width follows the depth: the flute narrows towards its ends. Open or closed paths. Tools: ball-nose bit, V-bit (recommended), end mill (constant width, sloped ends).

Depths:

  • Start depth, Final depth (as a value or a % of the stock): the flute goes down by the final depth minus the start depth.
  • Final width: the width at its widest, along the flat section. It is linked to the final depth by the tool profile: changing one recomputes the other (90° V-bit: width = 2 × depth; ball-nose bit: width = 2 √(depth × (diameter − depth)), then its diameter). With an end mill, the width is its diameter. Changing the tool, or its dimensions, recomputes the width; deeper than the profiled part of the tool (cone height, ball radius), the width no longer grows (warning).
  • Depth per pass: Dusty works out the number of passes (shown under the field). Each pass follows the same profile, deeper and deeper: no pass removes more than one depth per pass.

Ramps (“Strategy” group):

  • Entry style and Exit style: Linear (constant slope), Fall (goes in gently, then dives more and more), Arc (dives, then eases off down to the bottom), Ogee (S-shaped, flat at both ends), Smooth (eased ends, steady slope in the middle). The exit mirrors the entry of the same style.
  • Entry length and Exit length, as a length (10 mm by default) or a percentage of the path. A zero length gives a vertical plunge or retract.
  • Flat section (shown, not editable): the path length minus both ramps, in mm and %, on the longest path of the operation. When ramps are longer than a path, they are shortened there in the same proportion, with no flat section (warning).
  • Flute preview: under the ramps, the longest path straightened, seen from the top (the width all along) and from the side (the depth, and the bottom of each pass dotted), with the ramp limits marked. Vertical scales are enlarged for readability; with no shape assigned, a 100 mm sample path.

What Dusty does:

  • Start: a closed path starts at the point set with the Start point tool, otherwise at its first node; direction chosen with Reverse direction, otherwise the drawing’s. An open path starts at its nearest end (to the start point set, otherwise to the tool). The ramps of a closed path meet at the start point: the flute is shallowest there.
  • Passes in a row: on an open path, every other pass runs backward; on a closed path, the passes follow each other in the same direction. The tool is at the start depth at the end of each pass: no move in the air.
  • Feeds: descents at the ramp rate, flat section and climbs at the cutting feed.
  • The nearest path first; circles and arcs written as G2/G3.

Tip: for a column or a leg, draw evenly spaced parallel lines (Arrays tool), then a single Fluting operation for all of them.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.