Skip to content

Machining operations

Entering the material

How the tool starts each pass: plunge, zigzag ramp, spiral or helix, which bits can plunge, and why a ramp spares the tool in hardwood and aluminum.

How the tool starts each pass:

  • Plunge: straight down at the plunge rate. Simple, but hard on the tool in hard materials; only for center-cutting bits.
  • Zigzag ramp: the tool goes down while moving back and forth along the path, at the ramp angle (3° by default) and the ramp feed rate. Recommended for pockets and profiles in hardwood and aluminum.
  • Spiral (profile): continuous descent along the outline, one depth per pass per turn, then a flat turn at the bottom.
  • Helical: in a direct pocket, a small helix where there is the most room (without room, a zigzag ramp); with the trochoidal path, a helix on the circle of the first loop (CAM-41). A direct profile has no helix: Dusty makes a zigzag ramp.

V-carving always enters with a plunge (a V-bit is not suited to ramps).

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.