Skip to content

Machining operations

Start point and direction

Choose where each outline starts — on a straight side rather than in a corner — and reverse the direction of a shape with the Start Point tool.

By default, Dusty starts each outline where the tool arrives (the shortest way) and follows it in the direction set by the operation’s cut direction. To choose where a shape starts (for example on a straight side rather than in a corner, where the start leaves a small mark):

  • Start Point tool (D, tool column and Drawing menu): click the outline of a shape; it is selected and its start goes under the click, snapped to the nearest node (the nodes of the shape are shown as small gray squares). A green square marks the start. On an open path, the start goes to the nearest end.
    • Shift-click: reverses the direction of the shape; a green arrow shows it.
    • ⌘-click (Ctrl-click): default start and direction.
  • Edit › Reverse Direction (also in the Shapes menu of the toolbar): reverses the direction of the selected shapes; an open path then starts from its other end.

Effect on machining: the start applies to profiles and chamfers (the machined outline starts at the point nearest to the start, pushed to the end of a tab if it falls on one; an open path starts at the chosen end). The chosen direction applies to an along line profile; inside or outside, the operation’s cut direction (climb or conventional) decides, to keep the intended cut quality. Each choice is undone with ⌘Z and kept in the .dusty file.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.