Skip to content

Workholding

Jigs and indexing fixtures

For series or two-sided parts, a jig machined on the CNC puts every part back in the same place: three contact points, work zero on the jig, dowel pins for flipping.

For a series, or a part machined on both faces, a jig (a plate fixed to the table, with a pocket or stops) puts every part back in exactly the same place: you change the part, not the zero.

Jig (dark beige) fixed to the spoilboard: each pocket takes a part, pushed against three stops (black dots).
  • Three contact points locate a part: two stops on a long side, one on a short side; push the part against them, always the same way.
  • Machine the jig on the machine itself (a pocket shaped like the part with a few tenths of clearance, or holes for dowel pins): it is then aligned with the axes. Leave it fixed, or locate it with two dowel pins in the spoilboard.
  • Set the work zero on the jig (a pocket corner, a pin) and keep it as a position (see Positions and macros); a project template keeps the jig drawing on a tool layer, with the operations.
  • The pocket locates the part but does not hold it: add a clamp, a cam, tape or a screw.
  • For a flip (two faces): two dowel pins on either side, in the spoilboard and in the stock, symmetric about a line parallel to a machine axis; the flipped part drops back onto the same pins.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.