Skip to content

Workholding

Screwing to the spoilboard

Screw the stock into the spoilboard, the basic method for through cuts: screws in the waste, countersunk, brass or plastic, and not overtightened.

The stock is screwed into the spoilboard (MDF or plywood laid on the table, which you accept to cut into). Very strong and simple, it is the basic method for through cuts.

Screws (gray) in the waste, away from the toolpaths (blue): each dashed circle marks the margin to keep around a screw.
  • Put the screws in the waste, at least one bit diameter plus 5 mm away from the toolpaths; draw their places on layer T1 before screwing.
  • Use countersunk screws sunk below the surface, and pre-drill near the edges so as not to split the stock. Brass or plastic screws harm a bit that touches them less; a steel screw that gets hit breaks the bit and throws fragments.
  • Do not overtighten: a screw driven too hard bows a thin sheet. Several screws spread out are better than one very tight.
  • For a part cut out from the middle of the stock, add tabs, or a screw in an area of the part that will be cut away later.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.