Tutorials
Rest machining and tool change
A star-shaped tray in MDF: a 6 mm end mill clears most of the pocket, then a 3.175 mm one finishes the points with a rest pocket after a tool change.
Open the example — a 6 mm deep star-shaped catch-all tray in a 120 mm square of MDF: a large bit clears most of it quickly, a small one finishes the points.
- Project: stock 120 × 120 × 18 mm.
- Star: Drawing › Preset Shapes › Star, 5 sides, inner radius 50 %, radius 50 mm, in the middle of the stock (see Drawing tools).
- Tools: the 6 mm (tool no. 1) and 3.175 mm (tool no. 2) end mills.
- Pocket of the star with the 6 mm end mill: 6 mm deep, 1 mm passes, 700 mm/min.
- Rest pocket on the same star, with the 3.175 mm end mill, placed after the pocket: clearing tool diameter 6 mm (see Rest pocket).
- Preview: about 14 minutes. With the by operation colors of the machined part, the second operation only touches the points.
- On the machine: see Before sending an example to the machine. Clamps at the four corners, clear of the star. Z zero with the 6 mm end mill; at the tool change, Dusty stops the machine and the spindle: fit the 3.175 mm end mill, set only the Z zero again, then Resume… (see Tool change).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.