Skip to content

Tutorials

Single-line engraved ruler

A 100 mm ruler engraved in a wooden strip with a 20° V-bit: graduations drawn as open lines and repeated by an array, digits in a single-line font.

Open the example — a 100 mm ruler engraved in a 130 × 35 × 6 mm strip: graduations every 5 mm, digits and name in the Dusty Monotrait font.

  1. Project: stock 130 × 35 × 6 mm.
  2. Graduations: with the Path tool (L), vertical lines of 10 mm (centimeters) and 6 mm (half centimeters), 5 mm apart from 15 mm off the left edge; an array repeats them exactly.
  3. Digits: Text tool, Dusty Monotrait font, 4 mm, one digit under each long line: each letter is a single stroke, with no outline (see Single-line fonts).
  4. Tool: the 20° V-bit of 3.175 mm from the library.
  5. Operation: select all, Profile side On the line: the center of the tool follows the open lines as well as the letters; 0.4 mm deep in one pass, 300 mm/min.
  6. Preview: less than 3 minutes.
  7. On the machine: see Before sending an example to the machine. A flat stock and a precise Z zero: a 0.4 mm engraving forgives nothing. The tip of a 20° bit is fragile: keep the suggested feed.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.