Skip to content

Tutorials

Cutting board and juice groove

A hardwood cutting board: a juice groove cut with a ball nose bit, then a 15 mm cut-out with tabs, the groove first while the board is still held.

Open the example — a 230 × 150 mm board with rounded corners and a juice groove, in 15 mm hardwood.

  1. Project: stock 240 × 160 × 15 mm, almost the whole travel of a 3018.
  2. Groove: a 210 × 130 mm rectangle with 15 mm rounded corners, centered.
  3. Outline: a 230 × 150 mm rectangle with 20 mm rounded corners, centered, on another color.
  4. Tools: the 6 mm ball nose bit (tool no. 1) and the 6 mm 2-flute end mill (tool no. 2).
  5. Profile on the line of the groove, with the ball nose bit: 3 mm deep, 1 mm passes, 700 mm/min. The rounded bottom is easy to clean.
  6. Outside profile of the outline, with the end mill: 15.3 mm, 1 mm passes, 700 mm/min, tabs 10 mm long and 2 mm high. The groove comes first, while the board is still held everywhere (see Machining order).
  7. Preview: about 20 minutes.
  8. On the machine: see Before sending an example to the machine. Screws in the corners of the stock, clear of the cut (2 mm margin), or double-sided tape; frame the job to check the travel. A tool change separates the groove from the cut-out. Cut the tabs, sand, then apply a food-safe oil.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.